Covered with releasing films and agents. The entire piece is then bagged and vacuumed clean of air.
From there the piece is inserted into an autoclave, which is, basically, a large oven. The parts are heated to cure the carbon fiber and then the part is finished. Dry carbon parts can be produced with a much lower weight than wet lay-up parts since there is much less resin used (hence the "dry" name) and with a higher strength. Finished in 2 pack UV resistant high gloss clear coat.
Don't use cheap wet layup product. Our prices are competative by our lean overheads.This item is in the category "Vehicle Parts & Accessories\Motorcycle Parts\Other Motorcycle Parts". The seller is "carbondude1" and is located in this country: AU. This item can be shipped worldwide.